Table of Contents
  1. Introduction
  2. Installation
    1. Preparation
    2. Installation Instructions
    3. Starting your toilet
  3. Maintaining Efficiency
  4. Use and Care
  5. Troubleshooting
  6. Warranty

Starting the toilet

1. Add approximately 3 quarts of water to the 8 gallon bag of starter mulch. Mix thoroughly. (This is only to keep the mulch from dusting)

2. Open the compost cover by pressing on the toilet seat.

3. Add 2 gallons of the 8 gallon bag of starter mulch into the toilet.

4. Turn the mixer handle several times in the clockwise direction (10 Standard) or press and hold the micro switch behind the seat (20 Deluxe), until the mixer stops (approx 5 seconds). Then release the button and allowing the mixing arms to complete their cycle between each press (approx 1 minute).

Repeat 2 – 3 times until the mulch is evenly disbursed through the toilet.

5. Add another 2 gallons of starter mulch to the toilet.

6. Turn the mixer handle several times in the clockwise direction (10 Standard) or Press and hold the micro switch behind the seat (20 Deluxe), until the mixer stops (approx 5 seconds). Then release the button and allowing the mixing arms to complete their cycle between each press (approx 1 minute).

Repeat 2 – 3 times until the mulch is evenly disbursed through the toilet

. *** IMPORTANT ***

A majority or all of the mulch will fall through the grate and into the tray. THIS IS NORMAL - DO NOT EMPTY THE TRAY!

7. Adjust your thermostat to the appropriate setting using the chart below. (This may not be your ideal setting. See “Use and Care”, “Adjusting the Thermostat” )

Recommended settings

Number of users
Thermostat setting
1- 2
2-3
3-4
4-5
5-6
6-7

Your BioLet is now ready to use.

Previous Page -Installation      Next Page - Maintaining Efficiency

 

BioLet Privacy Policy
Close Window

Please wait...

BioLet Return Policy
Close Window

Please wait...

Support Registration
Close Window

Please wait...